Thermoguard Dualcoat Smoke and Flame Retardant Topcoat

Apply 1 or 2 coats over Thermocoat or Timbercoat basecoats as instructed by the system guide for the basecoat required.

Application Conditions
Do not apply in temperatures under 8°C or above 30°C.
Maximum relative Humidity below 75%.
Wood should be fully dry.
Surface should be at least 3°C above the dew point.

Preparation
Insulating and Thermocoat Basecoats must be clean and fully hard dry.
Stir well before use

Brush or Roller
Use a woven short pile roller sleeve or synthetic brush at rate stated on can.

Spray
Pressure Pot and Gun conventional with hand-portable compressor.
Thin 5% water
OR Airless Graco 1500, 3500 or equivalent. 3/8” line, 30 mesh filter on machine, no
filter in gun. 521, 523, 621 or 623 tips.
Ensure coverage is applied as per can i.e., 20 sq m can covers 20 sq metres.

Cleaning
Return as much unused material to its original container as possible. Wash brushes, rollers and guns with clean water immediately following use.

Coverage
specified by Thermogaurd in order to ensure the system meets certification standards

Drying Times
In normal conditions product will be touch dry in an hour and fully dry after 4 hours