Product Description
Sandtex 365 All Weather Smooth Exterior Masonry Paint like Palatine Pliocem Pliolite Masonry Paint is a solvent based, premium quality, smooth protective and decorative finish. For use on most exterior masonry surfaces and exterior grade building boards which will allow the product the ability to dry in adverse weather conditions and temperatures as low as -10ºC. Sandtex 365 offers up to 20 Years of Protection in colours including Vermont Grey, French Grey and Sandstone.
We can also mix other colours upon request, including Sandtex colours such as Vermont Grey and French Grey. However, please note that we are unable to make pastel colours. We also have Sandtex 365 available in white.
Touch dry in 1-2 hours. Leave 16 hours before overcoating.
Estimated Coverage: up to 10sqm per litre
Container Size: 5 Litre
For full details, please see the datasheets.
For water based alternatives take a look at Sandtex Trade X-treme X-posure Smooth Masonry Paint or Palatine Trutex Masonry Paint
Please note:
If you have purchased your required colour previously from an alternative Sandtex / Crown stockist or are looking to touch up existing painted surface please do not purchase this item, unless you are overcoating the whole area and accept there may be a possible colour differential.
We cannot guarantee an exact match on the colour due to differences in production batches and methods from various Crown / Sandtex stockists.
The Sandtex colours shown here are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently.
Preparation:
To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.