Product Description
Sandtex Trade X-treme X-posure is a water based outdoor masonry paint designed to protect against weather and the elements. It provides a durable coating with a proven 15 year protection against weather exposure. Sandtex Trade X-treme X-posure Paint is available in a variety of colours, including Plymouth Grey and Country Stone.
We can also mix other colours upon request, including Sandtex Paint colours such as Plymouth Grey, Country Stone, Vermont Grey. However, please note that we are unable to make white and pastel colours.
Touch dry in 30 minutes. Leave 2 to 4 hours before overcoating.
Estimated Coverage: up to 16sqm per litre
Container Size: 5 Litre
For full details, please see the datasheets.
We also stock Sandtex High Cover and 365 All Weather masonry paints.
Please note: If you have purchased your required colour previously from an alternative Sandtex / Crown stockist or are looking to touch up existing painted surface please do not purchase this item, unless you are overcoating the whole area and accept there may be a possible colour differential.
We cannot guarantee an exact match on the colour due to differences in production batches and methods from various Crown / Sandtex stockists
The Sandtex colours shown here are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Reviews
There are no reviews yet.