Palatine Paints polyurethane gloss varnish is a durable finish, which seals and protects a wide range of surfaces. With a wide range of properties it protects your wood work from knocks, heat, scratches and chemical spills. Use to brighten up colours and protect wooden surfaces.
Easy to use, protective varnish choice for high traffic areas. As well as wood, it can be used on: concrete; stone; slate; metal and other composite materials. You’ll need to apply two coats for the the full effect of the varnish. The varnish is easy to apply with a suitable brush or roller or by spray. We suggest sanding down the surface between coats.
Take a look at our Floor Varnish and Yacht Varnish for floors or outdoor use.
We are proud to be a member of the British Coatings Federation.
Colours Available: Clear.
Pack Sizes: 1 Litre, 2.5 Litre, 5 Litre.
Coverage / Drying Times:
Surface Dry: 3 hours
Hard Dry: 8 hours
Overcoat: after 24 hours
Keep coated areas dry for a minimum of 24 hours following application.
Please note, drying times will be extended at low temperatures. Do not apply when ambient temperature falls below 10ºC
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease etc.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
A minimum of two coats is recommended on bare wood to optimize the coatings performance.
Please note: The colours on the product listings are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently. Sample pots are available to order upon request. Always carry out a test patch (approximately 100x100mm) before full application to ensure compatibility with previous coatings and the substrate, and to ensure the colour achieved meets your requirements. Failure to do so will result in a product refund claim not being accepted.