Palatine Fast Dry Semi Gloss paint is a quick drying, solvent borne, semi-gloss finish, industrial strength top coat. It provides a tough, rust inhibiting, decorative finish and is ideal for use on steel work, railings, skips, containers and agricultural plant/machinery. Use as a direct to metal, fast drying, semi gloss coating for an excellent, high build, protective finish.
While Fast Dry Semi Gloss paint is self-priming, for additional anti-corrosive protection use Palatine Fast Dry Metal Primer. The drying properties make this an ideal paint for situations requiring quick, one day maintenance.
Highlights:
- Semi gloss alternative to Fast Dry Gloss direct to metal paint.
- Excellent for application by airless or conventional spray
- Can also be applied by roller (nylon, solvent resistant) or brushed (small areas)
- Ideal for steel work and items such as skips, containers, cabins, plant & machinery
Technical Summary:
Industrial semi-gloss, fast drying paint – self-priming long term protection to substrates such as: carbon steel; stainless steel; cast iron; wrought Iron and wood. Based on a short oil alkyd resin and containing modified binding pigments, providing a decorative sustainable finish.
Cleaning and Storage
- Cleaning: Clean tools with Palatine S063
- Storage: Store between 5ºC – 35ºC under cover in good conditions
- Shelf Life: 2 years in unopened containers, when stored under cover in good storage conditions
Properties
- Volume solids: 45% (may vary with colour)
- Flash Point: 25ºC
Please note: The colours shown here are only a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently.
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
For non-ferrous metals use Palatine Fast Dry etching primer.
A test area on unknown previously painted surfaces must be carried out prior to full application
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Rust removers based on phosphoric acid tend to leave an electrically insulating film on ferrous metals, therefore should be avoided (ask us for advice)
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine Multi Purpose Thinners by volume.
Apply an even coat using a brush (rapid strokes) or a solvent resistant roller.
Q: What is Fast Dry Semi-Gloss Paint used for?
A: It’s a quick-drying, solvent-borne industrial top coat that gives a tough, rust-inhibiting, semi-gloss decorative finish. It’s ideal for steelwork, railings, skips, containers, and agricultural plant/machinery.
Q: Do I need a primer, or is it self-priming?
A: It’s self-priming and can be used as a direct-to-metal coating. For extra anti-corrosive protection, overcoat Palatine Fast Dry Metal Primer first.
Q: What surfaces can it go on?
A: It’s designed for long-term protection on substrates such as carbon steel, stainless steel, cast iron, wrought iron, and wood (with correct preparation).
Q: How fast does it dry and when can I recoat?
A: Typical drying times are surface dry in 15 minutes and recoatable after 1 hour. Keep coated areas dry for at least 24 hours after application. Drying will be slower in colder conditions—don’t apply below 10°C.
Q: What happens if I use standard White Spirit instead of Multi-Purpose Thinners?
A: This is a common mistake. Standard white spirit is a “weaker” solvent. Using it with this fast-dry industrial paint can cause the paint to “curdle” in the tin or result in a finish that stays soft or tacky for days. Always stick to the recommended Palatine Multi-Purpose Thinners.
Angela Seaman (verified owner) –
We have been using the paint today, no problem. Its absolutely lovely paint, easy to use and covers really well. Very pleased.