Product Description
Carbosolv Multi Purpose paint thinners is part of our ever increasing Carbosolv range of thinners and solvents. This xylene based paint thinner is perfect for thinning Palatine’s following coatings:
- Carbofast Gloss and Semi Gloss finishes
- Fast Dry Primers.
- Chlorinated Rubber Paint
- Hammer Finish Paint
When thinning for spraying please refer to the technical data sheet of the relevant paint. This will offer guidance in order to dilute at the correct ratio. For most top coats the recommended dilution would be 1 part solvent to 10 parts paint or approximately 10%.
For primers such as Palatine Fast Dry Metal the recommended dilution would be 1.5 parts thinner to 10 parts paint or approximately 15%.
Also used for cleaning spray equipment and equipment such as solvent resistant rollers and brushes.
Multi Purpose Thinners is a high purity solvent.
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
Ideal enhanced protection beneath Palatine’s selected Top Coats.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 3 hours
Overcoat@ 20ºC: After 24 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.