Product Description
Hammershield Smooth Paint is a fast drying, decorative and protective direct to metal paint. Easy to use – this solvent borne, top coat, comes in hammered or smooth finish. Also suitable for use on wood, Hammershield Paint is ideal for garden furniture, gates, railings, garage doors and more. Works just as well as a quick way to spruce up garden pots, ornaments and play equipment.
Palatine Hammershield Paint provides a tough decorative coating. While ideal as top coat, this metal paint can be used with Fast Dry Metal Primer for ultimate rust protection.
Why Hammer Finish or Hammerite Paint?
- Fast drying paint – enables multi coat application in minimal time
- Direct to metal (DTM) – no need to prime except where surface is poor or superior rust inhibition is required
- Decorative – available in a smooth or hammered finish
- Protective – tough and durable finish for both metal and wood applications
- Competitively priced compared with major brands
If rust is a particular issue, we recommend applying a rust convertor then coating with Hammershield.
Available in 8 attractive shades for interior and exterior metalwork. Equivalent to a well-known major brand, our professional product is only available direct or from selected trade stockists.
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
We are proud to be a member of the British Coatings Federation.
Preparation:
To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.