Product Description
Promatic Paint Isolator Primer Spray creates a barrier between the existing paint on a surface and a new coating. It primarily prevents the existing coat from lifting or bleeding though to the new paint. In addition, the paint isolator protects against solvent attacks, which can occur when an existing coating is incompatible with the solvent in the new paint.
The sealer does not require sanding and can be overcoated with any type of single or 2K coating. These include our Chassis Spray Paint, available in a matt, satin or gloss finish in a wide range of colours. Other suitable coatings include our Coach Enamel, Plant and Machinery Paint and Indasa’s Acrylic Spray Paint.
Estimated coverage: 0.75 to 1m² per 500ml can
Drying times:
Dust Free 10-15 minutes
Touch Dry 30 minutes
Overcoat after 3 hours. Apply the first paint layer in a light coat
The drying time depends on temperature, humidity and the thickness of the applied coat.
• The surface must be free from all contamination including rust, grease and moisture.
• Before use, carefully read and note the warning text on the label.
• Spray from a distance of approx. 20 cm several thin cross-coats. To achieve sufficient protection, apply at least 3 cross-coats.
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Reviews
There are no reviews yet.