Product Description
Teamac Galley Paint is designed to reduce condensation that forms on interior surfaces of boats. It gives a lightly textured surface that can then be overcoated by other paints to provide a colour, such as Teamac Marine Gloss our our own Marine Gloss.
This paint is suitable for narrowboats, cruisers and yachts, and can be used in Galleys, Heads, Cabins and Ceilings.
Teamac Galley Paint is touch dry in 2 hours and hard dry in 12 hours. Leave 4 hours before overcoating.
For full details, please see the datasheets or contact us via the online chat, phone or email for any questions about this item or to check stock.
Surface Preparation
All surfaces should be clean, dry, sound and free from contaminants and grease. Scrape and brush the surface to remove any loose flaking material. Flat down glossy surfaces with abrasive paper. Treat any mould or lichen with a proprietary mould remover with a scraper or a stiff brush then treat again. Prime bare metal areas with Teamac Marine Primer Undercoat.
Mixing Instructions
This paint is thick by nature and once opened will require a thorough stir before use.
Application Conditions
Do not apply below 10 °C. As dictated by normal good painting practice. In confined spaces, provide adequate ventilation during application and drying.
For thinning and cleaning, use clean water.
Preceding Coat
Teamac Marine Primer Undercoat on bare metal.
Subsequent Coat
2 Full coats of Teamac Galley Paint.
Estimated Coverage
9sqm per litre
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Reviews
There are no reviews yet.