Marine Anti-Corrosive Primer Paint, an anti corrosive metal primer for iron and steel. The primer is based on alkyd resin and contains modified zinc phosphate and binding pigments. This means that long term protection is provided (see below).
A superior primer suitable for use under the High Build Marine Undercoat and Boat & Barge Professional Gloss topcoat. A choice of red, white or grey gives you several options to match your topcoat.
- Suitable for mild steel, carbon steel, stainless steel, cast and wrought iron
- Apply by brush or roller, for spray application take a look at our Fast Dry Metal Primer
- High in zinc phosphate for protection against corrosion
About rust and corrosion:
Both iron and steel are prone to rust because they’re generally exposed to air and moisture. Rust forms when iron reacts with oxygen and water, it then creates a coating on the metal surface. When rust isn’t treated, the reaction (or oxidisation process) continues. This results in corrosion, which causes significant damage to metal (see HSE for more details).
A quality primer like Carboxide Metal Primer paint will provide longer term protection against rust and corrosion. Our customers say it works even when a surface has already begun to ‘ginger’ with rust.
What to order? Our industrial quality primer for metal has coverage of 12 – 14m² per litre and pack sizes range from 1L right up to 5L. If you need any help or technical advice call us Mon to Fri 8am to 5pm. Alternatively use our online chat service or send us an email.
Colours available: Grey, Red, White
Pack Sizes: 500ml, 1 Lire, 2.5 Litre, 5 Litre, 20 Litre
Coverage / Drying Times:
Surface Dry: 3 hours
Hard Dry: 8 hours
Overcoat: after 24 hours
Keep coated areas dry for a minimum of 24 hours following application.
Please note, drying times will be extended at low temperatures. Do not apply when ambient temperature falls below 10ºC
Theoretical Coverage: 12 – 14m² per litre.
Thinning and Cleaning: Use Palatine White Spirit. If using more than one batch of the same colour, intermix before use
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
Ideal enhanced protection beneath Palatine’s selected Top Coats.
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 15% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Please note: The colours on the product listings are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently. Sample pots are available to order upon request. Always carry out a test patch (approximately 100x100mm) before full application
to ensure compatibility with previous coatings and the substrate, and to ensure the colour achieved meets your requirements. Failure to do so will result in a product refund claim not being accepted.