Indasa High Build Primer Plus Spray Grey 500ml

A single pack high build primer that can be applied to a range of surfaces.

  • Suitable for plastics
  • Ready to overcoat after 20 minutes
  • Can be coated a chosen refinish topcoat system, including water based
  • Superb build and scratch filling properties

£19.20 Excl. VAT

10 in stock

Stay Social. Connect with us. 

Product Description

Indasa High Build Primer Plus Spray is a single pack high build primer that can be applied to a range of automotive surfaces. It can be applied to areas of existing paint, bare metal and plastics without needing an adhesion promoter.

The finish is similar to a spray gun, with High Build Primer Plus able to be overcoated after 20 minutes.

For full details, please see the data sheets.

Preparation:

To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.

Application:

Best results are obtained in warm (minimum 10°C), dry conditions.

Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.

For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.

Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).

Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC

Thinners: White Spirit

If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]

Reviews

There are no reviews yet.

Be the first to review “Indasa High Build Primer Plus Spray Grey 500ml”

incl. tax excl. tax
A can of Indasa High Build Primer Plus Grey
Indasa High Build Primer Plus Spray Grey 500ml

10 in stock