Product Description
Coo-Var Profloor Plus Floor Paint is a low odour and solvent free floor paint for heavy duty use. It has outstanding resistance to both abrasion and chemicals, making it ideal for use in factories, workshops, stadiums and other public areas with high traffic.
Highly recommended for car garages and other surfaces that need a fuel and oil resistant floor coating, due to the chemical resistant properties
Coo-Var Profloor Plus is touch dry in 4 to 8 hours and hard dry in 24 to 36 hours. Full cure in 5 to 7 days. Accepts light traffic after 12 to 16 hours and heavy traffic after 36 hours.
Leave 8 hours and no more than 48 hours before overcoating, ensuring all tackiness is gone.
Estimated Coverage: 4 to 5sqm per kg
Container Size: 5kg (5L + 1L can)
For full details, please see the datasheets.
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Reviews
There are no reviews yet.