Product Description
Carbotrak tractor and implement paint dries fast to give a hard, protective, high gloss finish. Easy to apply and ideal for coating, touching up damage, or for restoration projects this tractor paint comes in most standard tractor shades and machinery paint colour codes. We supply paint for most tractor colours such as: Ford Tractor Blue, John Deere Yellow; Massey Ferguson Red etc.
Using Carbotrak, which is solvent borne, will help keep your surface smooth and chip free, even with the heavy usage sustained by this type of vehicle.
If you have agricultural machinery or equipment in need of protection, Carbotrak tractor and implement paint will help you perform the task quickly and effectively with lasting results. It is easy to apply with excellent wet edge and flow out. If you need a colour that is not listed below, we may be able to make it for you. Get in touch via our Contact Page.
- Quick drying machinery enamel
- Surface dry in two hours
- Superior wet edge and flow out
- Paint available in most manufacturer’s colours (Ford Tractor Blue, John Deere Yellow; Massey Ferguson Red etc)
- Matchable to RAL Classis and BS 381c/4800 codes
The correct solvent for thinning and cleaning for this product is Palatine White Spirit
Smooth any surface and apply suitable primer such as our Carboxide Metal Primer.
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
For Thinning and Cleaning use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Reviews
There are no reviews yet.