FREE SHIPPING AVAILABLE ON ORDERS OVER £75.00*
Timber Cladding Paint
Timber Cladding Paint is an oil based, opaque wood and timber coating, and is available in a range of colours. Provides protection against the elements for exterior wooden cladding.
Suitable for use with:
- Tongue and groove cladding
- Feather edge cladding
- Shiplap timber cladding
- Waney edge cladding
From £26.58 Excl. VAT
Stay Social. Connect with us.Â
Timber Cladding Paint is a durable long lasting coating that will protect exterior wood cladding for years to come. Touch dry in 3 hours. Recommended for brush or solvent resistant roller, however conventional and airless spray can be used. Because it is resilient and protective against the elements, it is a great choice for a wide range of timber cladding.
Available colours:
- Black
- Signal Grey
- Anthracite Grey
- Graphite Grey
- Slate Grey
- Mahogany Brown
We can colour match to RAL and BS colour codes, so you don’t have to forego appearance in favour of practicality
Oil based coatings are highly recommended over water based alternatives as once applied are resistant to moisture.
Coverage / Drying Times:
Surface Dry: 3 hours.
Hard Dry: 8 hours.
Overcoat: after 24 hours.
Keep coated areas dry for a minimum of 24 hours following application.
Please note, drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 10ºC
Theoretical Coverage: 12 – 14m² per litre.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
For maximum protection prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine A.P Primer/Undercoat in accordance with our recommendations.
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
For application as a finish coat or onto wooden surfaces, a minimum of two coats is recommended.
Product Documents
Download
Be the first to review “Timber Cladding Paint”
Reviews
There are no reviews yet.