Product Description
Carbowash Acid Brick Cleaner is a strong hydrochloric acid cleaner that removes stains, limescale and dirt. It is suitable for surfaces including brick, concrete, paving, scaffolding and tools.
- Covers an estimated 10 to 12sqm per litre
- Shake well before and during application
- Apply by brush or watering can
In case of heavy cement and mortar stains, try Carbochem Cement Remover
For further information on application and properties, please see the data sheets.
Please note:
the regulations to control consumers purchases, possession and use of commonly available chemicals which could be used to cause harm are to be updated from the 1st of October 2023. There are two distinct product categories: regulated and reportable substances.
Regulated substances – an EPP licence is required before regulated substances can be legitimately supplied to a member of the public. Businesses and professional users do not require EPP licences for regulated substances, where the substance is being used as part of their business or profession.
For business purposes please complete and return the attached declaration form
A member of the public must show their valid EPP licence and associated photo ID document before you can supply any regulated chemicals.
Members of the public who want to import, acquire, possess or use these chemicals must hold an Explosives Precursors and Poisons (EPP) licence issued by the Home Office and an associated photographic identity document. For further information see EPP licences: application guidance.
Preparation:
To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.