FREE SHIPPING AVAILABLE ON ORDERS OVER £75.00*
Epoxy Concrete Patch Repair System
Concrete Patch Repair System for use in the repair of worn, cracked and damaged concrete where a high strength repair material is required.
- Good abrasion resistance
- Good chemical resistance (specific chemical resistances should be checked with our Technical Department)
- Pre-weighed packs
£32.39 – £52.71
Stay Social. Connect with us.
Product Description
Concrete Patch Repair System is suitable as a fixing and maintaining kit to worn, cracked and damaged concrete. Carbofix is based on a blend of epoxy resin, curing agents and selected aggregates.
The Epoxy concrete repair kit provides a non-skid and abrasive resistant surface. Offers good resistance to dilute acids, petrol, oil and grease.
When cold temperatures are encountered the epoxy resin concrete repair is available in Palatine Carbofix Coldcrete to fix damage and cracks in low temperature areas.
- Good abrasion resistance
- Good chemical resistance
- Pre-weighed packs
- Walk on time at 20°C: 10-12 hours
- Full cure time: 7 days
Use with Epoxytread Primer if surface is in poor condition or on new, unmatured concrete.
Unsure which floor coating you need? Our blog gives information about where, when and how to use: polyurethane floor paint; two pack epoxy coatings and chlorinated rubber paint.
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Be the first to review “Epoxy Concrete Patch Repair System”
Reviews
There are no reviews yet.