Product Description
Brush Mate Service Pack (For Trade 20). All you need to service your Brush Mate Trade 20. The pack contains:
- 1 x vapour pad
- 4 x replacement brush clips
- 1 x drip mat
How often does the Brush Mate Trade 20 need ‘servicing’? Brush Mate recommends a service every 6 months to maintain the efficiency of the system.
Whilst in use the panel can slowly become clogged with paint and other contaminants. This may slow down the evaporation of fluid from the panel which might potentially lose its effectiveness. So that’s why your vapour panel should replaced when required. As well as a vapour pad, the service pack also contains a replacement drip mat and 5 spare brush clips.
Click here to buy the Brush Mate Trade 20
Do you hate the messy cleaning after using oil based paints and varnishes? The Brush Mate Trade 20 and Trade 4 allow you to store your brushes until you next need them. Just pop them into the Brush Mate and transport to your next job or store away until needed. Paint waste can have a significant impact on the environment so cutting down on the number of times you clean your brushes can help reduce that impact.
If you want to know more about reducing impact of paint waste on the environment, why not read our blog here. For more information on disposal of hazardous waste, visit the Health and Safety Executive’s website
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Reviews
There are no reviews yet.