FREE SHIPPING AVAILABLE ON ORDERS OVER £75.00*
Barrettine Mould & Mildew Cleaner 4L
a ready to use fungicidal wash and mould remover with a cleaning action to remove light dirt.
- Suitable for Masonry, Brick, Concrete, Plaster, Plastic, Timber and Tile
- Leaves surfaces clean for further treatment
- Apply direct by Brush, Roller or Spray
£9.69 exc VAT | £11.63 inc VAT
10 in stock (can be backordered)
Stay Social. Connect with us.
Product Description
Barrettine Mould and Mildew Cleaner is a ready to use fungicidal wash and mould remover. It contains biocides to control organic growths and spores and a cleaning action to remove light dirt.
This cleaner can be used indoors or outdoors to remove mould, mildew, algae and fungi. It is suitable for a range of surfaces including timber, concrete, brick, plaster, stone, tiles, masonry and plastic.
Please note: This product does not contain bleach and will not remove stains.
Estimated Coverage: 5 to 10sqm per litre
For full details, please see the datasheets.
Product Documents
Surface Preparation
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
The preparation of steelwork prior to painting generally falls into two main areas; that of degreasing and the removal of rust and scale.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Mixing
Stir the paint with a drill stirrer or wooden baton at least 2” wide. Continue to stir during application.
Application
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Preceding Coat
Prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine All Purpose Primer / Undercoat in accordance with our recommendations
For non-ferrous metals use Palatine Mordant Solution.
Subsequent Coat
A second coat is recommended for maximum protection.
Be the first to review “Barrettine Mould & Mildew Cleaner 4L”
Reviews
There are no reviews yet.