ProSolve 0-9 Stencil Kit

ProSolve 0-9 Stencil Kit – Easy to use. Simply, place the numbers where you want to create the mark suitable for use on walls and floors internally or externally. Apply a line marker and peel off the stencil.

From £8.52 Excl. VAT

Clear

Stay Social. Connect with us. 

Product Description

ProSolve 0-9 Stencil Kit – Easy to use. Simply, place the numbers where you want to create the mark suitable for use on walls and floors internally or externally. Apply a line marker and peel off the stencil.

Sizes Available :

  • X-small 2″
  • Small 3″
  • Medium 4″
  • Large 6″
  • X-Large 12″

Pair with ProSolve line marker hand held applicator for a quick and precise job. The stencil is suitable for indoor & outdoor use with a range of different paints why not try Prosolve Hi-Vis Marker Paints to make highly visible signage. Also ideal for use with ProSolve Stencil Spray Paint.

Preparation:

To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.

Application:

Best results are obtained in warm (minimum 10°C), dry conditions.

Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.

For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.

Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).

Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC

Thinners: White Spirit

If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]

Reviews

There are no reviews yet.

Be the first to review “ProSolve 0-9 Stencil Kit”

You may also like…

£29.40 Excl. VAT

Line Marking Stencils

ProSolve A-Z Stencil Kit

From £23.97 Excl. VAT

incl. tax excl. tax
ProSolve 0-9 Stencil Kit
ProSolve 0-9 Stencil Kit
From £8.52 Excl. VAT Select options