Coo-Var Graffiti Protection System Sealer Coat

SURFACE PREPARATION:
Remove existing graffiti with dedicated graffiti removal agents where required. Ensure that the substrate is free of any residue from graffiti removal agents. The surface must be clean, sound and free of any dust, dirt, oil and grease. If necessary wash substrate with high pressure water and allow to dry. Adhesion should be checked over all surfaces as follows to ensure suitability of GP101: – Dab GP101 with a small rag onto a small area of substrate (5-10cm² is sufficient) and allow to dry overnight. For signage and murals, after sufficient dry time has elapsed, rub firmly across the test area with finger for loss of adhesion. For other painted surfaces, rub firmly with a rag soaked with Thinners 14, then rub the surface by hand. If there is no evidence of GP101 peeling off the surface is compatible.

MIXING INSTRUCTIONS:
Stir well before use and use manageable quantities; Pour a small quantity into roller tray or spray unit as required. Then reseal container immediately. GP101 has a pot life of approximately two hours when exposed to the elements, can vary depending on the ambient conditions.

APPLICATION CONDITIONS:
As dictated by normal good painting practice. In confined spaces, provide adequate ventilation during application and drying.

PRECEDING COAT:
Coo-Var Anti-Graffiti Sealer Coat on porous and natural surfaces such as sandstone. Apply direct to non porous brick work and masonry.

SUBSEQUENT COAT: GP101 Graffiti & Flyposting Protection System