FREE SHIPPING AVAILABLE ON ORDERS OVER £75.00*
Self Adhesive Black and Yellow Hazard Warning Cloth Tape 50mm x 33m
Black and yellow self adhesive cloth floor tape makes marking out hazardous zones simple.
- Black and Yellow warning tape is ideal for social distancing measures and hazard zones
- For both temporary and permanent floor marking
- Easy to apply self adhesive, strong cloth tape which leaves no residue
- Highly visible in recognised black/yellow diagonal marking
- Ideal for warehouses and shops
£5.46 Excl. VAT
100 in stock
Stay Social. Connect with us.
Product Description
Black and Yellow self adhesive hazard floor tape is an essential part of your safety tool kit. Use it for both temporary and permanent floor marking. In black and yellow diagonals which signify a physical health or hazard zone.
- Yellow and black self-adhesive tape which is ideal for indicating social distancing and hazardous zones
- Does not leave a residue – perfect for temporary as well as permanent floor marking
- Easy to apply self adhesive, strong cloth tape
- Highly visible appearance makes areas easily identifiable and is a recognised marking
- Ideal for warehouses, the retail sector and more
Designed for heavy duty use, this floor marking warning tape will ensure employees and visitors take vital precautions when needed.
Read more information in our line marking blog
Preparation:
To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.