Carboxide oxide gloss paint is an excellent and practical, weatherproof paint. A traditional oxide gloss paint that will protect metal and wood. Touch dry in 3 hours. Recommended for brush or solvent resistant roller, however conventional and airless spray can be used. Because it is resilient and protective against the elements, it is a great choice for an agricultural and industrial gloss paint.
We can colour match to RAL and BS colour codes, so you don’t have to forego appearance in favour of practicality. Apply as a direct coat, but note that it will perform best when applied over selected selected primers and undercoats. Carboxide agricultural & industrial gloss has excellent coverage. For extra waterproof properties check out our Carbolustre 2000 barn paint.
- Oil Based Paint
- External Oxide Farm Gloss
The correct solvent for thinning and cleaning for this product is Palatine White Spirit
We are proud to be a member of the British Coatings Federation.
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
For maximum protection prime bare surfaces with Palatine Anti-Corrosive Metal Primer or Palatine A.P Primer/Undercoat in accordance with our recommendations.
For non-ferrous metals use Palatine Fast Dry etching primer.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
For application as a finish coat or onto wooden surfaces, a minimum of two coats is recommended.
Please note: The colours on the product listings are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently. Sample pots are available to order upon request. Always carry out a test patch (approximately 100x100mm) before full application to ensure compatibility with previous coatings and the substrate, and to ensure the colour achieved meets your requirements. Failure to do so will result in a product refund claim not being accepted.
Jack Wardley (verified owner) –
Excellent gear really hardwearing and brill coverage tints dry quicker also couldn’t really ask for more. J.W.Painting