Floor Preparation
Workwear & PPE
Rust Treatment
Workwear & PPE
Rust Treatment
Furniture Paint
FREE SHIPPING AVAILABLE ON ORDERS OVER £75.00*
A quick drying decorative and durable topcoat, perfect for repainting wood furniture in black, white and many other colours.
An oil based product with a Satin finish which gives a long term tough protective coating with a slight sheen.
Click Here for accessory bundleFrom £11.87 Excl. VAT
Stay Social. Connect with us.
Looking to paint your wooden furniture? Then no look further… Our Palatine Professional Furniture Paint is a quick drying decorative and durable topcoat, perfect for repainting wood furniture in black, white and many other colours.
This is an oil based product with a Satin finish which gives a long term tough protective coating with a slight sheen to the finish look. Satin gives a wipeable finished surface so don’t worry about messy fingers touching your furniture anymore!
This easy to use decorative topcoat is a cheaper alternative to Revive and rejuvenate rustic, antique furniture. Give that old looking wooden furniture a new life with a fresh coat of paint… Grey furniture paint is the way forward!
Touch dry in 3 hours and hard dry in 8 hours. Leave 24 hours before overcoating.
Estimated Coverage: 12 to 14sqm per litre… A little goes a long way!
Also available in an aerosol form.
Colours Available: 29 Standard, BS 381C, BS4800 and Ral Classic range.
Pack Sizes: 1 Litre, 2.5 Litre
Coverage / Drying Times:
Surface Dry: 3 hours
Hard Dry: 8 hours
Overcoat: after 24 hours
Keep coated areas dry for a minimum of 24 hours following application.
Please note, drying times will be extended at low temperatures. Do not apply when ambient temperature falls below 10ºC
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease and millscale, etc.
for a better finish, prime surfaces with Palatine All Purpose Primer / Undercoat in accordance with our recommendations
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces and a long pile roller on textured surfaces
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
If using more than one batch of the same colour, intermix before use
Please note: The colours on the product listings are only given as a guide. This is due to the fact that every computer monitor has a different capability to display colours. In addition, everyone sees these colours differently. Sample pots are available to order upon request. Always carry out a test patch (approximately 100x100mm) before full application
to ensure compatibility with previous coatings and the substrate, and to ensure the colour achieved meets your requirements. Failure to do so will result in a product refund claim not being accepted.
Reviews
There are no reviews yet.