Product Description
The ProSolve four-wheel line marking applicator is a straightforward piece of equipment, used to line mark well-kept grass and any hard surfaces. So whether your marking a grass root football pitch or a tarmacked car park this durable product will allow fast applied accurate lines.
This applicator takes 600ml & 750ml Aerosols.
With its quick and easy set up there is no time wasting, just pop in your acrylic line marker spray and start marking!
- Compatible with Prosolve semi-permanent and Prosolve temporary line-marker.
- 2 Inch Line Width
- Suitable for Indoor and Outdoors
- Holds 600ml & 750ml aerosols.
If your looking for an applicator for smaller sized aerosols then the range also has a hand held version which holds 500ml cans. This specific applicator is the best out of the range to use when marking close to walls, equipment and machinery. If your looking for an applicator which aids in irregular and curved lines then the deluxe 4 wheeled applicator is the best.
Also available:
Preparation:
To ensure a durable and effective bilge paint application, it’s crucial to properly prepare the surface. Start by cleaning the substrate thoroughly to remove any dirt, grease, or oil. You can use a degreaser or mineral spirits for this step. Next, inspect the surface for any rust or old paint. If present, remove the rust using a wire brush, sandpaper, grinder or suitable rust remover / treatment. For old paint, use a paint stripper or sand it down until you reach the bare metal. Once the surface is clean and free of rust and old paint, sand it with fine-grit sandpaper to create a smooth and slightly roughened surface for better paint adhesion. Finally, wipe down the steel with a clean cloth to remove any dust or debris before applying our rust-inhibitive marine primer. After the primer has dried, you can proceed with applying our high build marine undercoat and then one but preferably two coats of the bilge paint.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume.
A second coat can be applied at full strength. This will prolong the life and performance of the coating.
For application onto wooden surfaces, a minimum of two coats is recommended.
Drying Time @ 20ºC: Drying times will be extended at low temperatures.
Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC: 1 hours
Hard dry @ 20ºC: 4 hours
Overcoat@ 20ºC: After 8 hours (temperature dependent).
Theoretical Coverage: 12 – 14m² per litre.
(Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.)
Storage: Store in temperature range 5-40ºC
Thinners: White Spirit
If you have any questions or require any further assistance, please contact us on 01942 884122 or email [email protected]
Reviews
There are no reviews yet.